Added kconfig entry for MTD_SPI_NOR
Cc: Simon Glass <[email protected]>
Cc: Bin Meng <[email protected]>
Cc: Mugunthan V N <[email protected]>
Cc: Michal Simek <[email protected]>
Cc: Siva Durga Prasad Paladugu <[email protected]>
Signed-off-by: Jagan Teki <[email protected]>
---
drivers/mtd/spi-nor/Kconfig | 18 ++++++++++++++++++
1 file changed, 18 insertions(+)
diff --git a/drivers/mtd/spi-nor/Kconfig b/drivers/mtd/spi-nor/Kconfig
index d32486c..f0ea9f9 100644
--- a/drivers/mtd/spi-nor/Kconfig
+++ b/drivers/mtd/spi-nor/Kconfig
@@ -1,3 +1,19 @@
+menuconfig MTD_SPI_NOR
+ tristate "SPI-NOR device support"
+ help
+ This is the core SPI NOR framework which can be used to interact
SPI-NOR
+ to SPI driver interface layer and the SPI-NOR controller driver.
+
+ Unlike normal/generic spi controllers, they are few controllers which
are
+ exclusively used to connect SPI-NOR devices, called SPI-NOR
controllers.
+ So technically these controllers shouldn't reside at drivers/spi as
these
+ may effect the generic SPI bus functionalities, so this SPI-NOR core
acts
+ as a common core framework between the generic SPI controller drivers
vs
+ SPI-NOR controller drivers for SPI-NOR device access. Note that from
SPI-NOR
+ core to SPI drivers there should be an interface layer.
+
+if MTD_SPI_NOR
+
config MTD_M25P80
tristate "Support most SPI Flash chips (AT26DF, M25P, W25X, ...)"
help
@@ -13,3 +29,5 @@ config MTD_M25P80
Set up your spi devices with the right board-specific platform data,
if you want to specify device partitioning or to use a device which
doesn't support the JEDEC ID instruction.
+
+endif # MTD_SPI_NOR
--
1.9.1
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
