Some SerDes protocols might not enable all l2switch ports. In this case,
these ports should not be configured to perform Rx/Tx operations.
This also fixes an issue when flooded frames were also switched to
disabled ports and frames start to accumulate, consuming memory
and eventually causing head-of-line blocking for other frames.
Signed-off-by: Codrin Ciubotariu <codrin.ciubota...@nxp.com>
---
drivers/net/vsc9953.c | 12 ++++++++----
1 file changed, 8 insertions(+), 4 deletions(-)
diff --git a/drivers/net/vsc9953.c b/drivers/net/vsc9953.c
index ef1435f..2388438 100644
--- a/drivers/net/vsc9953.c
+++ b/drivers/net/vsc9953.c
@@ -2525,6 +2525,9 @@ void vsc9953_init(bd_t *bis)
if (vsc9953_port_init(i))
printf("Failed to initialize l2switch port %d\n", i);
+ if (!vsc9953_l2sw.port[i].enabled)
+ continue;
+
/* Enable VSC9953 GMII Ports Port ID 0 - 7 */
if (VSC9953_INTERNAL_PORT_CHECK(i)) {
out_le32(&l2ana_reg->pfc[i].pfc_cfg,
@@ -2537,6 +2540,11 @@ void vsc9953_init(bd_t *bis)
out_le32(&l2sys_reg->pause_cfg.mac_fc_cfg[i],
VSC9953_MAC_FC_CFG);
}
+
+ l2dev_gmii_reg = (struct vsc9953_dev_gmii *)
+ (VSC9953_OFFSET + VSC9953_DEV_GMII_OFFSET +
+ T1040_SWITCH_GMII_DEV_OFFSET * i);
+
out_le32(&l2dev_gmii_reg->port_mode.clock_cfg,
VSC9953_CLOCK_CFG);
out_le32(&l2dev_gmii_reg->mac_cfg_status.mac_ena_cfg,
@@ -2559,10 +2567,6 @@ void vsc9953_init(bd_t *bis)
/* WAIT FOR 2 us*/
udelay(2);
- l2dev_gmii_reg = (struct vsc9953_dev_gmii *)(
- (char *)l2dev_gmii_reg
- + T1040_SWITCH_GMII_DEV_OFFSET);
-
/* Initialize Lynx PHY Wrappers */
phy_addr = 0;
if (vsc9953_l2sw.port[i].enet_if ==
--
1.9.3
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
