On Saturday, March 19, 2016 5:43:52 PM CDT Dennis Gilmore wrote: > Hans, > > What is the status of this patch? > > Dennis
With the patch applied building for Cubietruck_plus fails with ld.bfd -pie --gc-sections -Bstatic -Ttext 0x4a000000 -o u-boot -T u- boot.lds arch/arm/cpu/armv7/start.o --start-group arch/arm/cpu/built-in.o arch/arm/cpu/armv7/built-in.o arch/arm/lib/built-in.o board/sunxi/built-in.o cmd/built-in.o common/built-in.o disk/built-in.o drivers/built-in.o drivers/dma/built-in.o drivers/gpio/built-in.o drivers/i2c/built-in.o drivers/mmc/built-in.o drivers/mtd/built-in.o drivers/mtd/onenand/built-in.o drivers/mtd/spi/built-in.o drivers/net/built-in.o drivers/net/phy/built-in.o drivers/pci/built-in.o drivers/power/built-in.o drivers/power/battery/built- in.o drivers/power/fuel_gauge/built-in.o drivers/power/mfd/built-in.o drivers/power/pmic/built-in.o drivers/power/regulator/built-in.o drivers/ serial/built-in.o drivers/spi/built-in.o drivers/usb/dwc3/built-in.o drivers/usb/emul/built-in.o drivers/usb/eth/built-in.o drivers/usb/gadget/ built-in.o drivers/usb/gadget/udc/built-in.o drivers/usb/host/built-in.o drivers/usb/musb-new/built-in.o drivers/usb/musb/built-in.o drivers/usb/phy/ built-in.o drivers/usb/ulpi/built-in.o fs/built-in.o lib/built-in.o net/ built-in.o test/built-in.o test/dm/built-in.o --end-group arch/arm/lib/ eabi_compat.o -L /usr/lib/gcc/armv7hl-redhat-linux-gnueabi/6.0.0 -lgcc -Map u-boot.map board/sunxi/built-in.o: In function `i2c_init_board': /builddir/build/BUILD/u-boot-2016.03/board/sunxi/board.c:363: undefined reference to `clock_twi_onoff' ld.bfd: BFD version 2.26.20160125 assertion fail elf32-arm.c:8434 ld.bfd: error: required section '.rel.plt' not found in the linker script ld.bfd: final link failed: Invalid operation > On Wednesday, January 27, 2016 4:34:44 PM CDT Chen-Yu Tsai wrote: > > Cubietruck Plus is a A83T/H8 based development board. The board has > > standard DDR3 SDRAM, AXP818 PMIC/codec, SD/MMC, eMMC, USB 2.0 host > > via HSIC USB Hub, USB OTG, SATA via USB bridge, gigabit ethernet, > > WiFi, headphone out / mic in, and various GPIO headers. > > > > The board also has an EEPROM on i2c0 which holds the MAC address. > > > > DLDO3 and DLDO4 provide power to the EMAC pins and PHY. Pin PA20 > > is connected to the reset control of the PHY. EMAC is not actually > > supported yet. > > > > The DTS is the same as the one already in the kernel. > > > > Signed-off-by: Chen-Yu Tsai <w...@csie.org> > > --- > > > > arch/arm/dts/Makefile | 1 + > > arch/arm/dts/sun8i-a83t-cubietruck-plus.dts | 65 > > > > +++++++++++++++++++++++++++++ configs/Cubietruck_plus_defconfig > > | > > 18 ++++++++ > > > > 3 files changed, 84 insertions(+) > > create mode 100644 arch/arm/dts/sun8i-a83t-cubietruck-plus.dts > > create mode 100644 configs/Cubietruck_plus_defconfig > > > > diff --git a/arch/arm/dts/Makefile b/arch/arm/dts/Makefile > > index 1c7d359..e338db5 100644 > > --- a/arch/arm/dts/Makefile > > +++ b/arch/arm/dts/Makefile > > @@ -184,6 +184,7 @@ dtb-$(CONFIG_MACH_SUN8I_A33) += \ > > > > sun8i-a33-sinlinx-sina33.dtb > > > > dtb-$(CONFIG_MACH_SUN8I_A83T) += \ > > > > sun8i-a83t-allwinner-h8homlet-v2.dtb \ > > > > + sun8i-a83t-cubietruck-plus.dtb \ > > > > sun8i-a83t-sinovoip-bpi-m3.dtb > > > > dtb-$(CONFIG_MACH_SUN8I_H3) += \ > > > > sun8i-h3-orangepi-pc.dtb \ > > > > diff --git a/arch/arm/dts/sun8i-a83t-cubietruck-plus.dts > > b/arch/arm/dts/sun8i-a83t-cubietruck-plus.dts new file mode 100644 > > index 0000000..88b1e09 > > --- /dev/null > > +++ b/arch/arm/dts/sun8i-a83t-cubietruck-plus.dts > > @@ -0,0 +1,65 @@ > > +/* > > + * Copyright 2015 Chen-Yu Tsai > > + * > > + * Chen-Yu Tsai <w...@csie.org> > > + * > > + * This file is dual-licensed: you can use it either under the terms > > + * of the GPL or the X11 license, at your option. Note that this dual > > + * licensing only applies to this file, and not this project as a > > + * whole. > > + * > > + * a) This file is free software; you can redistribute it and/or > > + * modify it under the terms of the GNU General Public License as > > + * published by the Free Software Foundation; either version 2 of the > > + * License, or (at your option) any later version. > > + * > > + * This file is distributed in the hope that it will be useful, > > + * but WITHOUT ANY WARRANTY; without even the implied warranty of > > + * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the > > + * GNU General Public License for more details. > > + * > > + * Or, alternatively, > > + * > > + * b) Permission is hereby granted, free of charge, to any person > > + * obtaining a copy of this software and associated documentation > > + * files (the "Software"), to deal in the Software without > > + * restriction, including without limitation the rights to use, > > + * copy, modify, merge, publish, distribute, sublicense, and/or > > + * sell copies of the Software, and to permit persons to whom the > > + * Software is furnished to do so, subject to the following > > + * conditions: > > + * > > + * The above copyright notice and this permission notice shall be > > + * included in all copies or substantial portions of the Software. > > + * > > + * THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, > > + * EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES > > + * OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND > > + * NONINFRINGEMENT. IN NO EVENT SHALL THE AUTHORS OR COPYRIGHT > > + * HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER LIABILITY, > > + * WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING > > + * FROM, OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR > > + * OTHER DEALINGS IN THE SOFTWARE. > > + */ > > + > > +/dts-v1/; > > +#include "sun8i-a83t.dtsi" > > + > > +/ { > > + model = "Cubietech Cubietruck Plus"; > > + compatible = "cubietech,cubietruck-plus", "allwinner,sun8i-a83t"; > > + > > + aliases { > > + serial0 = &uart0; > > + }; > > + > > + chosen { > > + stdout-path = "serial0:115200n8"; > > + }; > > +}; > > + > > +&uart0 { > > + pinctrl-names = "default"; > > + pinctrl-0 = <&uart0_pins_b>; > > + status = "okay"; > > +}; > > diff --git a/configs/Cubietruck_plus_defconfig > > b/configs/Cubietruck_plus_defconfig new file mode 100644 > > index 0000000..bb0b336 > > --- /dev/null > > +++ b/configs/Cubietruck_plus_defconfig > > @@ -0,0 +1,18 @@ > > +CONFIG_ARM=y > > +CONFIG_ARCH_SUNXI=y > > +CONFIG_MACH_SUN8I_A83T=y > > +CONFIG_DRAM_CLK=672 > > +CONFIG_DRAM_ZQ=15355 > > +CONFIG_DRAM_ODT_EN=y > > +CONFIG_MMC0_CD_PIN="PF6" > > +CONFIG_I2C0_ENABLE=y > > +CONFIG_AXP_GPIO=y > > +CONFIG_DEFAULT_DEVICE_TREE="sun8i-a83t-cubietruck-plus" > > +# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set > > +CONFIG_SPL=y > > +CONFIG_SYS_EXTRA_OPTIONS="RGMII,MACPWR=SUNXI_GPD(20)" > > +# CONFIG_CMD_IMLS is not set > > +# CONFIG_CMD_FLASH is not set > > +# CONFIG_CMD_FPGA is not set > > +CONFIG_AXP_DLDO3_VOLT=2500 > > +CONFIG_AXP_DLDO4_VOLT=3300 > > _______________________________________________ > U-Boot mailing list > U-Boot@lists.denx.de > http://lists.denx.de/mailman/listinfo/u-boot
signature.asc
Description: This is a digitally signed message part.
_______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot