On 04/20/2016 03:46 PM, Stephen Warren wrote:
From: Stephen Warren <[email protected]>Tegra20's PCIe controller has a couple of quirks. There are workarounds in the driver for these, but they don't work after the DM conversion: 1) The PCI_CLASS value is wrong in HW. This is worked around in pci_tegra_read_config() by patching up the value read from that register. Pre-DM, the PCIe core always read this via a 16-bit access to the 16-bit offset 0xa. With DM, 32-bit accesses are used, so we need to check for offset 0x8 instead. Mask the offset value back to 32-bit alignment to make this work in all cases. 2) Accessing devices other than dev 1 causes a data abort. Pre-DM, this was worked around in pci_skip_dev(), which the PCIe core code called during enumeration while iterating over a bus. The DM PCIe core doesn't use this function. Instead, enhance tegra_pcie_conf_address() to validate the bdf being accessed, and refuse to access invalid devices. Since pci_skip_dev() isn't used, delete it. I've also validated that both these WARs are only needed for Tegra20, by testing on Tegra30/Cardhu and Tegra124/Jetson TKx. So, compile them in conditionally. Fixes: e81ca88451cf ("dm: tegra: pci: Convert tegra boards to driver model for PCI") Signed-off-by: Stephen Warren <[email protected]>
TomW, I'd like to make sure this one gets into the upcoming release, since it's a functional bug-fix.
_______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
