On 21 June 2016 at 17:22, Siva Durga Prasad Paladugu <[email protected]> wrote: > Hi Tom, > >> -----Original Message----- >> From: Siva Durga Prasad Paladugu >> Sent: Tuesday, June 14, 2016 2:48 PM >> To: [email protected]; 'Siva Durga Prasad Paladugu' >> <[email protected]>; [email protected] >> Cc: Michal Simek <[email protected]> >> Subject: RE: [PATCH v2 1/3] spi: spi_flash: Dont set quad enable for micron >> in all >> cases >> >> -----Original Message----- >> From: Siva Durga Prasad Paladugu [mailto:[email protected]] >> Sent: Thursday, May 26, 2016 12:28 PM >> To: [email protected] >> Cc: Michal Simek <[email protected]>; [email protected]; Siva Durga >> Prasad Paladugu <[email protected]> >> Subject: [PATCH v2 1/3] spi: spi_flash: Dont set quad enable for micron in >> all >> cases >> >> Dont set quad enable for micron devices in all cases Setting the quad enable >> bit >> in micron expects all other commands like register reads on quad lines which >> may not be supported by some controllers. Hence, dont set the quad enable if >> controller driver sets the no_all_quad. >> >> Hi Jagan, >> >> Any comments on this series. If not, Please take this series. >> >> Regards, >> Siva > > If Jagan is busy, Is it possible to get it acked/reviewed from some other > person and can go through your tree/Michal tree.
These are big changes on common code, please add cover-letter, describe the text and send again. thanks! -- Jagan. _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
