Hi Tom, > -----Original Message----- > From: U-Boot [mailto:[email protected]] On Behalf Of Tom Rini > Sent: Saturday, July 16, 2016 6:51 AM > To: [email protected] > Cc: [email protected]; [email protected] > Subject: Re: [U-Boot] [U-Boot, 3/3] stm32: Change USART port to USART6 for > stm32f746 discovery board > > On Fri, Jul 08, 2016 at 01:02:26AM +0900, [email protected] wrote: > > > From: Toshifumi NISHINAGA <[email protected]> > > > > This change is to remove a halt at about 200KiB while sending a > > large(1MiB) binary to a micro controller using USART1. > > USART1 is connected to a PC via an on-board ST-Link debugger that also > > functions as a USB-Serial converter. > > However, it seems to loss some data occasionally. > > So I changed the serial port to USART6 and connected it to the PC > > using an FTDI USB-Serial cable, therefore the transmission was > > successfully completed. > > > > Signed-off-by: Toshifumi NISHINAGA <[email protected]> > > Applied to u-boot/master, thanks!
There is no serial/usb connector on discovery board to use USART6 signals. With this patch, it is not possible to get discovery console without additional circuit. Please revert this patch. Also I did a quick check on transferring 2.6MB binary using usart1 without any issue. Hi Toshifumi, Please keep all involved developers in the "To" of the patch e-mails (checkout scripts/get_maintainer.pl). Cheers, Vikas > > -- > Tom _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
