Dear Heiko Schocher, In message <4aaf1fe4.9050...@denx.de> you wrote: > U-Boot can detect if an IDE device is present or not. > If not, and this new config option is activated, U-Boot > removes the ATA node from the DTS before booting Linux, > so the Linux IDE driver does not probe the device and > crash. This is needed for buggy hardware (uc101) where > no pull down resistor is connected to the signal IDE5V_DD7. > > Signed-off-by: Heiko Schocher <h...@denx.de>
Seems this patch depends on other patches, that add support for the manroland boards, which have not been accepted yet. I think I'm waiting for a resubmit from you? Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de ATTENTION: Despite Any Other Listing of Product Contents Found Here- on, the Consumer is Advised That, in Actuality, This Product Consists Of 99.9999999999% Empty Space. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot