On Wed, Sep 23, 2009 at 9:05 PM, Tom <tom....@windriver.com> wrote: > Minkyu Kang wrote: >> Dear Tom >> >> 2009/9/23 Tom <tom....@windriver.com>: >>> Minkyu Kang wrote: >>>> Adds new board SMDKC100 that uses s5pc100 SoC >>>> >>>> Signed-off-by: Minkyu Kang <mk7.k...@samsung.com> >>>> Signed-off-by: HeungJun, Kim <riverful....@samsung.com> >>>> --- > > <snip> > >>>> +#ifndef CONFIG_ONENAND_IPL >>>> + /* setting SRAM */ >>>> + ldr r0, =S5PC100_SROMC_BASE >>>> + ldr r1, =0x9 >>>> + str r1, [r0] >>>> +#endif >>> Where is CONFIG_ONENAND_IPL defined ? >>> If it is not being used, the #ifndef logic should be reduced. >> >> Kyungmin Park sent the patch that is supported onenand_ipl for s5pc1xx. >> but not yet applied onenand_ipl patch for s5pc1xx. >> When that patch is applied, we need these logic. >> If necessary, I'll delete these logic until apply the patch. >> > > If the patch already exits, it would be better if it was in this > patchset. Can we get the onenand_ipl patch ?
To support the s5pc1xx OneNAND IPL. It needs to refactor the current OneNAND IPL. Now I refactor the OneNAND IPL code first and then I will send a OneNAND IPL codes for s5pc1xx. I want to leave current patch as is. Since If we delete the OneNAND IPL codes. No one can refer the codes. I mean OneNAND IPL parts contains clock and memory configuration. These are helpful to someone who use NAND or NOR. Thank you, Kyungmin Park _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
