SYSCLK is used as a reference clock for USB. When the USB controller is used, SYSCLK must meet the additional requirement of 100 MHz.
Signed-off-by: Sriram Dash <[email protected]> --- arch/arm/cpu/armv8/fsl-layerscape/fdt.c | 20 ++++++++++++++++++++ 1 file changed, 20 insertions(+) diff --git a/arch/arm/cpu/armv8/fsl-layerscape/fdt.c b/arch/arm/cpu/armv8/fsl-layerscape/fdt.c index 40d6a76..1a8321b 100644 --- a/arch/arm/cpu/armv8/fsl-layerscape/fdt.c +++ b/arch/arm/cpu/armv8/fsl-layerscape/fdt.c @@ -108,6 +108,24 @@ remove_psci_node: } #endif +void fsl_fdt_disable_usb(void *blob) +{ + int off; + /* + * SYSCLK is used as a reference clock for USB. When the USB + * controller is used, SYSCLK must meet the additional requirement + * of 100 MHz. + */ + if (CONFIG_SYS_CLK_FREQ != 100000000) { + off = fdt_node_offset_by_compatible(blob, -1, "snps,dwc3"); + while (off != -FDT_ERR_NOTFOUND) { + fdt_status_disabled(blob, off); + off = fdt_node_offset_by_compatible(blob, off, + "snps,dwc3"); + } + } +} + void ft_cpu_setup(void *blob, bd_t *bd) { #ifdef CONFIG_FSL_LSCH2 @@ -150,4 +168,6 @@ void ft_cpu_setup(void *blob, bd_t *bd) #ifdef CONFIG_SYS_DPAA_FMAN fdt_fixup_fman_firmware(blob); #endif + fsl_fdt_disable_usb(blob); + } -- 2.1.0 _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
