On Wed, Aug 24, 2016 at 2:35 PM, Roger Quadros <[email protected]> wrote: > Both ethernet ports can be used as CPSW ethernet (RMII mode) > or PRU ethernet (MII mode) by setting the jumper near the port. > Read the jumper value and set the pinmux, external mux and > PHY clock accordingly. > > As jumper line is overridden by PHY RX_DV pin immediately > after bootstrap (power-up/reset), we have to use GPIO edge > detection to capture the jumper line status. > > As u-boot doesn't provide any infrastructure for GPIO edge > detection, we directly access the GPIO registers. > > Signed-off-by: Roger Quadros <[email protected]>
Acked-by: Joe Hershberger <[email protected]> _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
