Hi Jaehoon,
How can I enable the CONFG_MMC_TRACE? I couldn't find this option in the menuconfig. Is it enough to add "CONFIG_MMC_TRACE=y" in the .config file? Best regards. Oscar Gomez Fuente. On 12 October 2016 at 06:46, Jaehoon Chung <jh80.ch...@samsung.com> wrote: > Hi > > On 10/11/2016 11:08 PM, Oscar Gomez Fuente wrote: > > Hi everyone, > > > > I've just compiled u-boot for a picoZed platform with > > the zynq_picozed_defconfig, and I've realised that the NET and SD Card > > aren't recognised. In the init I see these messages: > > > > I boot from the SD Card and I see these messages from my uart terminal: > > > > --------------------- > > U-Boot 2016.11-rc1-00139-gf5fd45f (Oct 11 2016 - 15:48:54 +0200) > > > > Model: Zynq PicoZed Board > > Board: Xilinx Zynq > > DRAM: ECC disabled 1 GiB > > MMC: > > Using default environment > > > > In: serial@e0001000 > > Out: serial@e0001000 > > Err: serial@e0001000 > > Model: Zynq PicoZed Board > > Board: Xilinx Zynq > > Net: No ethernet found. > > ** Bad device mmc 0 ** > > Checking if uenvcmd is set ... > > Hit any key to stop autoboot: 0 > > --------------------- > > > > So, I think something has broken. Could anyone chek this issue? > > Could you enable the CONFIG_MMC_TRACE? then we can see more information. > And which config do you use? > > Best Regards, > Jaehoon Chung > > > > > > > Thank you very much. Best regards. > > > > Oscar Gomez Fuente > > _______________________________________________ > > U-Boot mailing list > > U-Boot@lists.denx.de > > http://lists.denx.de/mailman/listinfo/u-boot > > > > > > > > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot