This adds the required code to set up a ULPI USB port, for
new NXP USB PHY used in QorIQ platforms.

To use this both CONFIG_USB_ULPI and CONFIG_USB_ULPI_VIEWPORT
have to be set in the board configuration file.

Signed-off-by: Rajesh Bhagat <rajesh.bha...@nxp.com>
---
Changes in v3:
 - Rebased to u-boot-usb master

Changes in v2:
 - Changes return value from -1 to ulpi_init ret value

 drivers/usb/host/ehci-fsl.c | 21 +++++++++++++++++++++
 1 file changed, 21 insertions(+)

diff --git a/drivers/usb/host/ehci-fsl.c b/drivers/usb/host/ehci-fsl.c
index 9c32921..85b810d 100644
--- a/drivers/usb/host/ehci-fsl.c
+++ b/drivers/usb/host/ehci-fsl.c
@@ -17,6 +17,9 @@
 #include <fsl_usb.h>
 #include <fdt_support.h>
 #include <dm.h>
+#ifdef CONFIG_USB_ULPI
+#include <usb/ulpi.h>
+#endif
 
 #include "ehci.h"
 
@@ -190,6 +193,10 @@ static int ehci_fsl_init(int index, struct usb_ehci *ehci,
        size_t len;
        char current_usb_controller[5];
 #endif
+#ifdef CONFIG_USB_ULPI
+       int ret;
+       struct ulpi_viewport ulpi_vp;
+#endif
 #ifdef CONFIG_SYS_FSL_USB_INTERNAL_UTMI_PHY
        char usb_phy[5];
 
@@ -257,6 +264,20 @@ static int ehci_fsl_init(int index, struct usb_ehci *ehci,
                udelay(1000); /* delay required for PHY Clk to appear */
                if (!usb_phy_clk_valid(ehci))
                        return -EINVAL;
+
+#ifdef CONFIG_USB_ULPI
+               ulpi_vp.viewport_addr = (u32)&ehci->ulpi_viewpoint;
+               ulpi_vp.port_num = 0;
+
+               ret = ulpi_init(&ulpi_vp);
+               if (ret) {
+                       puts("NXP ULPI viewport init failed\n");
+                       return ret;
+               }
+
+               ulpi_set_vbus(&ulpi_vp, 1, 1);
+               ulpi_set_vbus_indicator(&ulpi_vp, 1, 1, 1);
+#endif
                out_le32(&(hcor)->or_portsc[0], PORT_PTS_ULPI);
        }
 
-- 
2.6.2.198.g614a2ac

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to