Hi, Simon,
Thank you for your reply.
In order to activate pin control function using "pinctrl-0" property, the
device driver itself has to be aware of the pin control existence, right?
So if I put such property under SPI controller, the SPI controller driver
has to handle call to the pin control driver methods, right?
However my current target is to trigger setup for all existent pin
controllers regardless of the connected device entries.
Unfortunately not all drivers are aware of the pin controller properties.
For instance current SPI and I2C drivers does not trigger the pin
controller "probe" method regardless of the "pinctrl-0" property presence
in FDT.
Regards
Konstantin
On Fri, Nov 18, 2016 at 3:14 AM, Simon Glass <s...@chromium.org> wrote:
> Hi Konstantin,
>
> On 15 November 2016 at 06:56, Konstantin Porotchkin <kos...@gmail.com>
> wrote:
> > Hi, All,
> >
> > I am currently porting the Marvell (mvebu) pin control driver for
> Armada-8K
> > family to the current u-boot sources.
> > The Armada 8K SoC is a hybrid chip that contains several interconnected
> > dies in a single package.
> > Each such device (AP, CP0, CP1) has an independent pin controller with
> > different memory mapping.
> > The DTS for such configuration looks like the following:
> > / {
> > ap806 {
> > config-space {
> > pinctl: pinctl@6F4000 {
> > ...
> > };
> > };
> > };
> > cp110-master {
> > config-space {
> > cpm_pinctl: pinctl@44000 {
> > ...
> > };
> > };
> > };
> > cp110-slave {
> > config-space {
> > cps_pinctl: pinctl@44000 {
> > ...
> > };
> > };
> > };
> > };
> >
> > I expect that my driver "probe" method will be called 3 times - one for
> > every controller.
> > However, according to my test, only the first controller is probed
> > (pinctl@6F4000).
> > Two others are listed in the DM tree, but are not active (not probed).
> >
> > I can do a trick and sequentially call uclass_get_device() function for
> > the UCLASS_PINCTRL type, causing all 3 controller to be probed and
> > activated.
> > However I think this is not the way it should work.
> > Is my assumption wrong and such hybrid devices should use the above trick
> > for bringing up all controllers in the package?
>
> They should be activated automatically by devices that use them. This
> is the pinctrl-0 property in the device. Can you take a look at why
> that is not working?
>
> Specifically, see pinctrl_select_state() in device_probe().
>
> Regards,
> Simon
>
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
