On 10.1.2017 15:05, stefan.herbrechtsme...@weidmueller.com wrote: > Hi Michal, > >> -----Ursprüngliche Nachricht----- >> Von: Michal Simek [mailto:michal.si...@xilinx.com] >> Gesendet: Dienstag, 10. Januar 2017 14:30 >> An: Herbrechtsmeier, Stefan; michal.si...@xilinx.com; >> jh80.ch...@samsung.com; u-boot@lists.denx.de >> Cc: s...@chromium.org; mon...@monstr.eu; swar...@nvidia.com >> Betreff: Re: AW: [PATCH v3 3/4] mmc: zynq: Determine base clock >> frequency via clock framework >> >> On 10.1.2017 10:16, stefan.herbrechtsme...@weidmueller.com wrote: >>> Hi Michael >>> >>>> -----Ursprüngliche Nachricht----- >>>> Von: Michal Simek [mailto:michal.si...@xilinx.com] >>>> Gesendet: Dienstag, 6. Dezember 2016 13:59 >>>> An: Jaehoon Chung; Herbrechtsmeier, Stefan; u-boot@lists.denx.de >>>> Cc: Michal Simek; Simon Glass; Albert Aribaud; Michal Simek; Stephen >>>> Warren >>>> Betreff: Re: [PATCH v3 3/4] mmc: zynq: Determine base clock >> frequency >>>> via clock framework >>>> >>>> On 5.12.2016 23:22, Jaehoon Chung wrote: >>>>> On 12/02/2016 10:24 PM, stefan.herbrechtsme...@weidmueller.de >> wrote: >>>>>> From: Stefan Herbrechtsmeier >>>>>> <stefan.herbrechtsme...@weidmueller.de> >>>>>> >>>>>> The zynq_sdhci controller driver use CONFIG_ZYNQ_SDHCI_MAX_FREQ as >>>>>> base clock frequency but this clock is not fixed and depends on >> the >>>>>> hardware configuration. Additionally the value of >>>>>> CONFIG_ZYNQ_SDHCI_MAX_FREQ doesn't match the real base clock >>>>>> frequency of SDIO_FREQ. Use the clock framework to determine the >>>> frequency at run time. >>>>>> >>>>>> Signed-off-by: Stefan Herbrechtsmeier >>>>>> <stefan.herbrechtsme...@weidmueller.de> >>>>> >>>>> >>>>> Even if this patch is delegated to Michal, i picked to this. >>>>> Applied on u-boot-mmc. >>>>> >>>> >>>> Based on my reply in v2 this is not ideal patch >>>> http://lists.denx.de/pipermail/u-boot/2016-November/274310.html >>>> >>>> Not a problem to take these patches should mmc tree but please wait >>>> till you have Ack from me. >>>> >>> Will you ack the patch if I remove the zynq specific code and remove >> the CONFIG_CLK check with my patch series to move zynq clk driver to >> DM? >> >> Just going to look at our clk changes for zynq and it can be the part >> of this series. > Okay. > >> Do you have branch somewhere with pending stuff? > > I have no public branch.
ok. Can you please send it as the part of clk series you made? I see that at least this patch will be different. Thanks, Michal _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
