Add an option for building Platorm Controller Hub drivers in SPL.
Signed-off-by: Simon Glass <[email protected]>
Reviewed-by: Bin Meng <[email protected]>
---
Changes in v3: None
Changes in v2: None
common/spl/Kconfig | 9 +++++++++
drivers/Makefile | 1 +
2 files changed, 10 insertions(+)
diff --git a/common/spl/Kconfig b/common/spl/Kconfig
index 57d38924c84..e07a6c8f853 100644
--- a/common/spl/Kconfig
+++ b/common/spl/Kconfig
@@ -445,6 +445,15 @@ config SPL_PCI_SUPPORT
necessary driver support. This enables the drivers in drivers/pci
as part of an SPL build.
+config SPL_PCH_SUPPORT
+ bool "Support PCH drivers"
+ depends on SPL
+ help
+ Enable support for PCH (Platform Controller Hub) devices in SPL.
+ These are used to set up GPIOs and the SPI peripheral early in
+ boot. This enables the drivers in drivers/pch as part of an SPL
+ build.
+
config SPL_POST_MEM_SUPPORT
bool "Support POST drivers"
depends on SPL
diff --git a/drivers/Makefile b/drivers/Makefile
index 00dc041f1b2..34c55bfb2ff 100644
--- a/drivers/Makefile
+++ b/drivers/Makefile
@@ -34,6 +34,7 @@ obj-$(CONFIG_SPL_ETH_SUPPORT) += net/
obj-$(CONFIG_SPL_ETH_SUPPORT) += net/phy/
obj-$(CONFIG_SPL_USBETH_SUPPORT) += net/phy/
obj-$(CONFIG_SPL_PCI_SUPPORT) += pci/
+obj-$(CONFIG_SPL_PCH_SUPPORT) += pch/
obj-$(CONFIG_SPL_RTC_SUPPORT) += rtc/
obj-$(CONFIG_SPL_TIMER_SUPPORT) += timer/
obj-$(CONFIG_SPL_MUSB_NEW_SUPPORT) += usb/musb-new/
--
2.11.0.483.g087da7b7c-goog
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
