From: Markus Niebel <[email protected]> fix the reset delay which was to short
Signed-off-by: Markus Niebel <[email protected]> --- board/tqc/tqma6/tqma6_mba6.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/board/tqc/tqma6/tqma6_mba6.c b/board/tqc/tqma6/tqma6_mba6.c index 02705be..6d63953 100644 --- a/board/tqc/tqma6/tqma6_mba6.c +++ b/board/tqc/tqma6/tqma6_mba6.c @@ -125,7 +125,7 @@ static void mba6_setup_iomuxc_enet(void) /* Reset PHY */ gpio_direction_output(ENET_PHY_RESET_GPIO , 0); /* Need delay 10ms after power on according to KSZ9031 spec */ - udelay(1000 * 10); + mdelay(10); gpio_set_value(ENET_PHY_RESET_GPIO, 1); /* * KSZ9031 manual: 100 usec wait time after reset before communication @@ -133,7 +133,7 @@ static void mba6_setup_iomuxc_enet(void) * BUGBUG: hardware has an RC const that needs > 10 msec from 0->1 on * reset before the phy sees a high level */ - udelay(200); + mdelay(15); } static iomux_v3_cfg_t const mba6_uart2_pads[] = { -- 1.9.1 _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
