On 05/13/2017 10:51 PM, Marek Vasut wrote:
> From: Kouei Abe <kouei.abe...@renesas.com>
> 
> R-Car Gen3 series have four SD card interfaces (SDHI0 to SDHI3),
> two of which can also be used as MMC interfaces (SDHI2 and SDHI3).
> This adds High-speed mode SD clock frequency between 25MHz and 50MHz,
> 8bit/4bit bus width, high capacity and low voltage device support.
> 
> Signed-off-by: Kouei Abe <kouei.abe...@renesas.com>
> Cc: Hiroyuki Yokoyama <hiroyuki.yokoyama...@renesas.com>
> Cc: Nobuhiro Iwamatsu <iwama...@nigauri.org>
> Cc: Jaehoon Chung <jh80.ch...@samsung.com>

Reviewed-by: Jaehoon Chung <jh80.ch...@samsung.com>

> ---
>  drivers/mmc/sh_sdhi.c | 14 ++++++++++++++
>  1 file changed, 14 insertions(+)
> 
> diff --git a/drivers/mmc/sh_sdhi.c b/drivers/mmc/sh_sdhi.c
> index c64beb6e2a..d181b63905 100644
> --- a/drivers/mmc/sh_sdhi.c
> +++ b/drivers/mmc/sh_sdhi.c
> @@ -698,6 +698,19 @@ static const struct mmc_ops sh_sdhi_ops = {
>       .init           = sh_sdhi_initialize,
>  };
>  
> +#ifdef CONFIG_RCAR_GEN3
> +static struct mmc_config sh_sdhi_cfg = {
> +     .name           = DRIVER_NAME,
> +     .ops            = &sh_sdhi_ops,
> +     .f_min          = CLKDEV_INIT,
> +     .f_max          = CLKDEV_HS_DATA,
> +     .voltages       = MMC_VDD_165_195 | MMC_VDD_32_33 | MMC_VDD_33_34,
> +     .host_caps      = MMC_MODE_4BIT | MMC_MODE_8BIT | MMC_MODE_HS |
> +                       MMC_MODE_HS_52MHz,
> +     .part_type      = PART_TYPE_DOS,
> +     .b_max          = CONFIG_SYS_MMC_MAX_BLK_COUNT,
> +};
> +#else
>  static struct mmc_config sh_sdhi_cfg = {
>       .name           = DRIVER_NAME,
>       .ops            = &sh_sdhi_ops,
> @@ -708,6 +721,7 @@ static struct mmc_config sh_sdhi_cfg = {
>       .part_type      = PART_TYPE_DOS,
>       .b_max          = CONFIG_SYS_MMC_MAX_BLK_COUNT,
>  };
> +#endif
>  
>  int sh_sdhi_init(unsigned long addr, int ch, unsigned long quirks)
>  {
> 

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot

Reply via email to