Dear ashish priyadarshi, In message <[email protected]> you wrote: > > We have a special "Serial flash controller" which was put into the standard > flash > framework of uboot (common/cmd_flash.c). Commands like 'cp', 'erase' could > be > used for operation over serial flash.
What do you mean by "Serial flash controller"? Some storage device similar to NAND or SPI Flash? This would not fit, then. > Since we felt "Serial flash controller" resembles SPI flash framework, and > hence > decided to move it there. Problem is that this "Serial flash controller" is > also not > fitting in SPI framework because of its nature. So you already learned that your serial flash is not a type of memory, but a storage device. You cannot use the memory interface as used for NOR flash for it. > How to handle such situations, is there any other framework or we need to > introduce > our own commands? We are using "u-boot-2009.08". That's difficult to impossible to answer - you don't provide any information what exact sort of device you have or why it would (not) fit into the SPI flash code. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [email protected] "I've seen it. It's rubbish." - Marvin the Paranoid Android _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
