Dear J.Hwan.Kim, > Hi, everyone > > I'm trying to connect ethernet with AT91SAM9260. > My board uses DM9161A as a ethernet transceiver.
> > The u-boot ethernet initialization routine runs auto-negotiation, > it works fine. Ethernet controller of AT91SAM9260 > (MACB0) receives Auto negotiation completion bit > from DM9161A status register. Please check phy interface mode: RMII or MII > > But status registor of DM9161A returns "Invalid link status", > so u-boot prints "eth0 link down". > > When does the "invalid link status" situation happen? > How can I fix this problem? > I connected the ethernet with PC by cross ethernet cable. > Which version of U-Boot do you use? Have You test the connection with an ethernet siwtch? Best Regards, J. Scharsig _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
