From: Fabio Estevam <fabio.este...@nxp.com>
There is no need call setup_display() from SPL code, so move it to
board_init(), which executes only in U-Boot proper.
Reported-by: Stefano Babic <sba...@denx.de>
Signed-off-by: Fabio Estevam <fabio.este...@nxp.com>
---
board/freescale/mx6sabresd/mx6sabresd.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/board/freescale/mx6sabresd/mx6sabresd.c
b/board/freescale/mx6sabresd/mx6sabresd.c
index 5b50bc8..f14b759 100644
--- a/board/freescale/mx6sabresd/mx6sabresd.c
+++ b/board/freescale/mx6sabresd/mx6sabresd.c
@@ -620,9 +620,6 @@ int board_ehci_power(int port, int on)
int board_early_init_f(void)
{
setup_iomux_uart();
-#if defined(CONFIG_VIDEO_IPUV3)
- setup_display();
-#endif
return 0;
}
@@ -639,6 +636,9 @@ int board_init(void)
setup_i2c(1, CONFIG_SYS_I2C_SPEED, 0x7f, &mx6q_i2c_pad_info1);
else
setup_i2c(1, CONFIG_SYS_I2C_SPEED, 0x7f, &mx6dl_i2c_pad_info1);
+#if defined(CONFIG_VIDEO_IPUV3)
+ setup_display();
+#endif
#ifdef CONFIG_USB_EHCI_MX6
setup_usb();
#endif
--
2.7.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
