Dear Wolfgang, > In message <[email protected]> you wrote: >> >> > > I haven't looked at the code differences between the sp3xx boards, but >> > > you might be able to use 1 common board file/header file to support them >> > > all. For example, take a look at the M5475AFE_config rule in >> > > U-Boot's ./Makefile. Some extra code in the Makefile and some #ifdefs >> > > in the sp3xx code might accommodate all 3 boards. >> > >> > Extra code in the Makefile should not be needed any more. >> >> To be clear, you still think its a good idea to look into combining the >> similar boards, correct? I haven't dealt with the MKCONFIG voodoo, so > > Yes, of course. > >> maybe I chose a poor example. Perhaps the CPCI405 and friends is a >> better example? > > Or this: > > 2485 P1011RDB_config \ > 2486 P1011RDB_NAND_config \ > 2487 P1011RDB_SDCARD_config \ > 2488 P1011RDB_SPIFLASH_config \ > 2489 P1020RDB_config \ > 2490 P1020RDB_NAND_config \ > 2491 P1020RDB_SDCARD_config \ > 2492 P1020RDB_SPIFLASH_config \ > 2493 P2010RDB_config \ > 2494 P2010RDB_NAND_config \ > 2495 P2010RDB_SDCARD_config \ > 2496 P2010RDB_SPIFLASH_config \ > 2497 P2020RDB_config \ > 2498 P2020RDB_NAND_config \ > 2499 P2020RDB_SDCARD_config \ > 2500 P2020RDB_SPIFLASH_config: unconfig > 2501 @$(MKCONFIG) -t $(@:_config=) P1_P2_RDB ppc mpc85xx p1_p2_rdb > freescale > > > No scripting any more in the Makefile :-)
Ok. Used the above example to combine SPEAr boards Best Regards Vipin _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
