On 12/09/2017 03:02 PM, Joe Hershberger wrote: > On Sat, Dec 9, 2017 at 4:59 PM, Florian Fainelli <f.faine...@gmail.com> wrote: >> Hi all, >> >> This patch series adds support for the Broadcom BCM53xx switches, in >> particular >> BCM53125 which is found no the Lamobo R1 board. >> >> The driver is largely based on the DSA/b53 driver Linux driver and only >> incorporates what is necessary to succesfully bring-up all ports (including >> the >> management port) for boot over the network: >> >> => dhcp >> dw_adjust_link: Speed: 1000, full duplex >> BOOTP broadcast 1 >> DHCP client bound to address 192.168.0.11 (3 ms) >> Using ethernet@01c50000 device >> TFTP from server 192.168.0.1; our IP address is 192.168.0.11 >> Filename 'sun7i-a20-lamobo-r1-kernel.bin'. >> Load address: 0x42000000 >> Loading: ################################################################# >> ################################################################# >> ################################ >> 11.6 MiB/s >> done >> Bytes transferred = 2371552 (242fe0 hex) >> => >> >> Joe there is one warning left which does not look legit to me since we now >> have >> a help paragraph describing the config symbol: >> >> WARNING: please write a paragraph that describes the config symbol fully >> #34: FILE: drivers/net/phy/Kconfig:15: >> +config B53_SWITCH >> >> and one CHECK left which I intentionally did not fix because it makes the >> definitions of the bits less clear: >> CHECK: Prefer using the BIT macro >> #134: FILE: drivers/net/phy/b53.c:63: >> +#define PORT_OVERRIDE_SPEED_100M (1 << PORT_OVERRIDE_SPEED_S) > > Works for me.o
Should I expect you to queue up these patches in a git tree/branch, or is someone else picking up networking/PHY patches? -- Florian _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot