On 01/11/2018 08:19 AM, Goldschmidt Simon wrote:
> This driver has been using printf() including filename since it was
> added. Convert to using debug() instead.
>
> Signed-off-by: Simon Goldschmidt <[email protected]>
Applied, thanks.
> ---
>
> drivers/ddr/altera/sequencer.c | 8 ++++----
> 1 file changed, 4 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/ddr/altera/sequencer.c b/drivers/ddr/altera/sequencer.c
> index 6c6bd90e94..42e87b50d3 100644
> --- a/drivers/ddr/altera/sequencer.c
> +++ b/drivers/ddr/altera/sequencer.c
> @@ -3534,7 +3534,7 @@ static void debug_mem_calibrate(int pass)
> u32 debug_info;
>
> if (pass) {
> - printf("%s: CALIBRATION PASSED\n", __FILE__);
> + debug("%s: CALIBRATION PASSED\n", __FILE__);
>
> gbl->fom_in /= 2;
> gbl->fom_out /= 2;
> @@ -3553,7 +3553,7 @@ static void debug_mem_calibrate(int pass)
> writel(debug_info, &phy_mgr_cfg->cal_debug_info);
> writel(PHY_MGR_CAL_SUCCESS, &phy_mgr_cfg->cal_status);
> } else {
> - printf("%s: CALIBRATION FAILED\n", __FILE__);
> + debug("%s: CALIBRATION FAILED\n", __FILE__);
>
> debug_info = gbl->error_stage;
> debug_info |= gbl->error_substage << 8;
> @@ -3570,7 +3570,7 @@ static void debug_mem_calibrate(int pass)
> writel(debug_info, &sdr_reg_file->failing_stage);
> }
>
> - printf("%s: Calibration complete\n", __FILE__);
> + debug("%s: Calibration complete\n", __FILE__);
> }
>
> /**
> @@ -3741,7 +3741,7 @@ int sdram_calibration_full(void)
>
> initialize_tracking();
>
> - printf("%s: Preparing to start memory calibration\n", __FILE__);
> + debug("%s: Preparing to start memory calibration\n", __FILE__);
>
> debug("%s:%d\n", __func__, __LINE__);
> debug_cond(DLEVEL >= 1,
>
--
Best regards,
Marek Vasut
_______________________________________________
U-Boot mailing list
[email protected]
https://lists.denx.de/listinfo/u-boot
