On 18/01/2018 15:47, Eric Nelson wrote:
> This patch just changes the order of configuration items in
> mx6memcal_defconfig to match the Kconfig layout, making it easier
> to track changes made using menuconfig.
> 
> Signed-off-by: Eric Nelson <e...@nelint.com>
> ---
>  configs/mx6memcal_defconfig | 9 ++++-----
>  1 file changed, 4 insertions(+), 5 deletions(-)
> 
> diff --git a/configs/mx6memcal_defconfig b/configs/mx6memcal_defconfig
> index 9a3bb83..b27330c 100644
> --- a/configs/mx6memcal_defconfig
> +++ b/configs/mx6memcal_defconfig
> @@ -9,25 +9,24 @@ CONFIG_SPL_WATCHDOG_SUPPORT=y
>  CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=arch/arm/mach-imx/spl_sd.cfg,SPL,MX6QDL"
>  CONFIG_SPL=y
>  CONFIG_HUSH_PARSER=y
> -# CONFIG_MMC is not set
>  # CONFIG_CMD_BOOTD is not set
>  # CONFIG_CMD_BOOTM is not set
>  # CONFIG_CMD_ELF is not set
>  # CONFIG_CMD_IMI is not set
> -# CONFIG_CMD_IMLS is not set
>  # CONFIG_CMD_XIMG is not set
>  # CONFIG_CMD_EXPORTENV is not set
>  # CONFIG_CMD_IMPORTENV is not set
>  # CONFIG_CMD_EDITENV is not set
>  # CONFIG_CMD_SAVEENV is not set
>  # CONFIG_CMD_ENV_EXISTS is not set
> -CONFIG_CMD_MEMTEST=y
>  CONFIG_CMD_MEMINFO=y
> -# CONFIG_CMD_LOADB is not set
> -# CONFIG_CMD_LOADS is not set
> +CONFIG_CMD_MEMTEST=y
>  # CONFIG_CMD_FLASH is not set
>  # CONFIG_CMD_FPGA is not set
> +# CONFIG_CMD_LOADB is not set
> +# CONFIG_CMD_LOADS is not set
>  # CONFIG_CMD_NET is not set
>  # CONFIG_CMD_NFS is not set
>  CONFIG_CMD_CACHE=y
> +# CONFIG_MMC is not set
>  CONFIG_REGEX=y
> 

Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot

Reply via email to