To platforms has two enet interface, using dev->seq could
avoid conflict.
i.MX6UL/ULL evk board net get the wrong MAC address from fuse,
eth1 get MAC0 address, eth0 get MAC1 address from fuse. Set the
priv->dev_id to device->seq as the real net interface alias id then
.fec_get_hwaddr() read the related MAC address from fuse.
Signed-off-by: Peng Fan <peng....@nxp.com>
---
drivers/net/fec_mxc.c | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/drivers/net/fec_mxc.c b/drivers/net/fec_mxc.c
index 2bd4ba4ef1..2c3171ecc9 100644
--- a/drivers/net/fec_mxc.c
+++ b/drivers/net/fec_mxc.c
@@ -1252,7 +1252,6 @@ static int fecmxc_probe(struct udevice *dev)
struct eth_pdata *pdata = dev_get_platdata(dev);
struct fec_priv *priv = dev_get_priv(dev);
struct mii_dev *bus = NULL;
- int dev_id = -1;
uint32_t start;
int ret;
@@ -1273,9 +1272,9 @@ static int fecmxc_probe(struct udevice *dev)
}
fec_reg_setup(priv);
- priv->dev_id = (dev_id == -1) ? 0 : dev_id;
- bus = fec_get_miibus((ulong)priv->eth, dev_id);
+ priv->dev_id = dev->seq;
+ bus = fec_get_miibus((ulong)priv->eth, dev->seq);
if (!bus) {
ret = -ENOMEM;
goto err_mii;
--
2.14.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
