On Mon, May 14, 2018 at 8:57 PM, Vasily Khoruzhick <anars...@gmail.com> wrote: > That is necessary for using automatic calibration on A64 eMMC. > > Signed-off-by: Vasily khoruzhick <anars...@gmail.com> > --- > arch/arm/mach-sunxi/Kconfig | 1 + > drivers/mmc/sunxi_mmc.c | 2 +- > 2 files changed, 2 insertions(+), 1 deletion(-) > > diff --git a/arch/arm/mach-sunxi/Kconfig b/arch/arm/mach-sunxi/Kconfig > index f0c9d1b058..376380e977 100644 > --- a/arch/arm/mach-sunxi/Kconfig > +++ b/arch/arm/mach-sunxi/Kconfig > @@ -256,6 +256,7 @@ config MACH_SUN50I > select SUNXI_DE2 > select SUNXI_GEN_SUN6I > select SUNXI_HIGH_SRAM > + select MMC_SUNXI_HAS_NEW_MODE > select SUPPORT_SPL > select SUNXI_DRAM_DW > select SUNXI_DRAM_DW_32BIT > diff --git a/drivers/mmc/sunxi_mmc.c b/drivers/mmc/sunxi_mmc.c > index fe6d82c7b4..65d88ee921 100644 > --- a/drivers/mmc/sunxi_mmc.c > +++ b/drivers/mmc/sunxi_mmc.c > @@ -165,7 +165,7 @@ static int mmc_set_mod_clk(struct sunxi_mmc_priv *priv, > unsigned int hz) > } > > if (new_mode) { > -#ifdef CONFIG_MMC_SUNXI_HAS_NEW_MODE > +#if defined(CONFIG_MMC_SUNXI_HAS_NEW_MODE) && !defined(CONFIG_MACH_SUN50I) > val = CCM_MMC_CTRL_MODE_SEL_NEW;
This is breaking eMMC boot on A64 U-Boot SPL 2018.05-00431-gf4fcaa5f15 (May 27 2018 - 23:59:42 +0530) DRAM: 1024 MiB Trying to boot from MMC2 unable to select a mode mmc_load_image_raw_sector: mmc block read error SPL: failed to boot from all boot devices ### ERROR ### Please RESET the board ### _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot