On Sat, 5 Jan 2019 at 10:01, Jagan Teki <[email protected]> wrote: > > On Sat, Jan 5, 2019 at 7:27 AM Simon Glass <[email protected]> wrote: > > > > Hi Jagan, > > > > On Tue, 1 Jan 2019 at 12:17, Jagan Teki <[email protected]> wrote: > > > > > > Migration plan for DM_SPI_FLASH is v2019.07 since it > > > depends on DM_SPI migration. > > > > > > Signed-off-by: Jagan Teki <[email protected]> > > > --- > > > Changes for v2: > > > - none > > > > > > Makefile | 10 ++++++++++ > > > 1 file changed, 10 insertions(+) > > > > > > diff --git a/Makefile b/Makefile > > > index c4d827f259..3e926d839f 100644 > > > --- a/Makefile > > > +++ b/Makefile > > > @@ -964,6 +964,16 @@ ifneq ($(CONFIG_DM_SPI)$(CONFIG_OF_CONTROL),yy) > > > @echo >&2 "See doc/driver-model/MIGRATION.txt for more info." > > > @echo >&2 "====================================================" > > > endif > > > +endif > > > +ifeq ($(CONFIG_SPI_FLASH),y) > > > > Again i worry what happens if the board does not actually use SPI flash? > > If SPI_FLASH not used then it will not enter this loop since its ifeq > (not even to check next ifneq). Did you find any config to enter even > if not used, same case for SPI.
OK I see. Reviewed-by: Simon Glass <[email protected]> _______________________________________________ U-Boot mailing list [email protected] https://lists.denx.de/listinfo/u-boot
