On Tue, Jan 29, 2019 at 11:20 PM Andre Przywara <[email protected]> wrote: > > On Tue, 29 Jan 2019 23:12:17 +0530 > Jagan Teki <[email protected]> wrote: > > Hi, > > > On Tue, Jan 29, 2019 at 9:24 PM Andre Przywara > > <[email protected]> wrote: > > > > > > This series gathers all remaining patches we need to enable DM_MMC > > > for Allwinner boards. It relies on the clock gates framework > > > already merged, and adds the respective gates and resets for each > > > SoC. It then teaches the sunxi MMC driver to use the clock > > > framework for those reset and gates clocks. The "mod clock", > > > responsible for setting the actual interface speed, is still > > > handled in the MMC driver, as the DM_CLK part of that is not ready > > > yet (and is not trivial). This allows to turn on DM_MMC, and gets > > > rid of the doomsday warning message every Allwinner board was > > > blessed with for a while. > > > > > > This series is available at: > > > https://github.com/apritzel/u-boot/commits/sunxi-dm-gates > > > > > > --------------------------- > > > > > > Jagan, can you please have a look whether this is fine? If you are > > > not sure about patch 7, you can leave this one out for now. > > > If you are good with it, can you merge it to sunxi/master and send > > > the PR, so that it still goes into the release? > > > We can then fix all the remaining issues until the release. > > > > > > Cheers, > > > Andre. > > > > > > Changes in v4: > > > - Add proper A80 support (special MMC config clock) > > > - Add V3s support (gates and resets) > > > - Fix pinmux problem when not booting via SD or eMMC > > > - smaller fixes per ML discussion > > > Changes for v3: > > > - Handle clock via CLK framework. > > > Changes for v2: > > > - update the 'reset enablement' logic to do > > > required SoC's > > > > > > Andre Przywara (5): > > > sunxi: clk: enable clk and reset for CCU devices > > > sunxi: clk: add MMC gates/resets > > > sunxi: clk: A80: add MMC clock support > > > mmc: sunxi: Add DM clk and reset support > > > sunxi: board: do MMC pinmux setup for DM_MMC builds > > > > Does this fix any issue? not sure why is this part of DM_MMC? in fact > > I didn't see any issues. > > This fixes boot via FEL or SPI flash, where the SPL won't setup the > pinmux for us. I should have mentioned that explicitly in the commit > message, sorry.
np, may be i will add while applying. and is this FEL issue that Pritt pointed out? > > > > > > > Jagan Teki (4): > > > mmc: sunxi: Add remaining compatible strings > > > mmc: sunxi: Add DM_MMC support for H6 > > > arm: sunxi: Enable DM_MMC > > > arm: dts: sunxi: Enumerate MMC2 as MMC1 > > > > I have next version change for this? will replace. > > > > patch [1] should be also be part of the DM_MMC w/o this SD is unable > > to detect in sopine boards. > > I know, if you are OK with it, can you please add it to the series, at > best with your Reviewed-by? Otherwise we can still take it later as a > fix. Will take this, anyway. _______________________________________________ U-Boot mailing list [email protected] https://lists.denx.de/listinfo/u-boot
