Implement method board_phy_config to configure the phy for pcb120.
Signed-off-by: Horatiu Vultur <[email protected]>
---
board/mscc/ocelot/ocelot.c | 15 +++++++++++++++
1 file changed, 15 insertions(+)
diff --git a/board/mscc/ocelot/ocelot.c b/board/mscc/ocelot/ocelot.c
index 532d06f..bcae8fa 100644
--- a/board/mscc/ocelot/ocelot.c
+++ b/board/mscc/ocelot/ocelot.c
@@ -11,6 +11,7 @@
#include <spi.h>
#include <led.h>
#include <wait_bit.h>
+#include <miiphy.h>
DECLARE_GLOBAL_DATA_PTR;
@@ -42,6 +43,20 @@ void mscc_switch_reset(bool enter)
mscc_gpio_set_alternate(19, 0);
}
+int board_phy_config(struct phy_device *phydev)
+{
+ if (gd->board_type == BOARD_TYPE_PCB123)
+ return 0;
+
+ phy_write(phydev, 0, 31, 0x10);
+ phy_write(phydev, 0, 18, 0x80F0);
+ while (phy_read(phydev, 0, 18) & 0x8000)
+ ;
+ phy_write(phydev, 0, 31, 0);
+
+ return 0;
+}
+
void board_debug_uart_init(void)
{
/* too early for the pinctrl driver, so configure the UART pins here */
--
2.7.4
_______________________________________________
U-Boot mailing list
[email protected]
https://lists.denx.de/listinfo/u-boot
