Dear Alexander Stein,
In message <201005311458.18454.alexander.st...@systec-electronic.com> you wrote:
>
> during board setup the ethernet is configured including the PHY. This takes
> an
> amount of time even if the cable is plugged in. It takes even more time of
> the
> initialization runs into a timeout if no cable is put in.
> Is there a possibility to defer the net initialization up to that point where
> the first net access is done, e.g. tftp command and leave the net
> uninitialized during normal startup using fsload and bootm.
Which version of U-Boot and which architecture / board are you talking
about?
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
PoB = "Prisoner of Bill" -- those held captive, unwillingly or other-
wise, by the contemptible Microsoft monopoly.
-- Tom Christiansen in <6abo45$3l...@csnews.cs.colorado.edu>
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
