Hi Ben,
Am Dienstag, 1. Juni 2010 21:03:51 schrieb Ben Warren:
> Also, remove all calls to eth_init() in boards that use MACB
>
> Signed-off-by: Ben Warren <[email protected]>
After cherry-picking ecee9324d73555e744593f3e0d387bec4c566f55 in my v2010.3
based tree and removing eth_init in reset_phy there is no boot delay due to
resetting the phy which is done in *_macb_hw_init.
Also the MAC address is programmed into hardware and doesn't need to be set by
ifconfig eth0 hw ether ${MAC}
One side note, but this shouldn't matter at all: I tested this on my own
board, not on of the boards with in-tree support in u-boot
Tested-by: Alexander Stein <[email protected]>
Best regards
Alexander
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
