Dear Wolfgang Denk On Wed, Jun 2, 2010 at 2:07 PM, Wolfgang Denk <[email protected]> wrote: > Dear Maxime Boure, > > In message <[email protected]> you > wrote: >> >> >> #define CONFIG_SYS_ENV_SECT_SIZE boot_flash_sec >> >> #define CONFIG_ENV_OFFSET boot_flash_off >> >> #define ONENAND_ENV_OFFSET 0x200000 /* environment starts here >> >> */ >> >> #define CONFIG_ENV_ADDR ONENAND_ENV_OFFSET >> > >> > Well, and what are the seffings for boot_flash_sec, boot_flash_off ? >> My settings : >> boot_flash_base 0x20000000 boot_flash_off 0x200000 boot_flash_sec >> 0x20000 boot_flash_env_addr 0x200000 > > CONFIG_ENV_SIZE is still missing...
#define CONFIG_ENV_SIZE SZ_512K /* Total Size Environment * and #define SZ_512K 0x00080000 > >> Device offset --> if I set /dev/mtd2 and this mtd is the one with the >> environment it has to be set to 0x0000 > > Right, this matches your MTD settings (partition mtd2 starts at the > same offset 0x200000. > > However, in your board configuration above I see that CONFIG_ENV_ADDR > (which is supposed to be an *address* is defined with an *offset* > value. This looks wrong to me. I would be surprised if this works, but > then - I haven't worked with OneNAND yet. > >> Env. size --> the size is 0x80000 > > I cannot comment on this - I haven't seen the CONFIG_ENV_SIZE settings > from your board config. It could be as well that you have two > redundant copies (of smaller size, obviously) in your partition. > >> Flash sector size --> is the erase block size so in my case 0x40000 > > Above you write that CONFIG_SYS_ENV_SECT_SIZE = boot_flash_sec = > 0x20000. This is inconsistent, then. > I tried with this configuration in fw_env.config : /dev/mtd2 0x0000 0x80000 0x20000 I had this error with the command fw_printenv : Too few good blocks within range >> Number of sectors ---> well ... I don't really know :) > > This depends on the sizes, and on how many redundant copies you > maintain. We don't know your board config file... > >> I am wrong ? > > Yes - otherwise there would be no problems ;-) Indeed... > > Best regards, > > Wolfgang Denk > > -- > DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel > HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany > Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [email protected] > Landing: a controlled mid-air collision with a planet. > Best regards, Maxime _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
