On 18/06/2019 08:50, Jagan Teki wrote: > On Thu, May 16, 2019 at 6:56 AM Andre Przywara <andre.przyw...@arm.com> wrote:
Hi, >> this series enables USB support on the H6 boards. This is mostly just >> adding some missing pieces here and there, the actual controller and PHY >> are very similar to the previous ones, if not identical. >> This is for the 2.0 ports only at the moment, USB 3.0 will be done >> later (started porting Icenowy's Linux driver). >> The Pine H64 shares a similar problem as the Pine64+ boards regarding >> the upper USB port. To enable this port, we need the first patch >> from the series [1] fixing this issue on the A64 boards. >> >> Patch 1 is a drive-by patch to bring SUNXI_GPIO to Kconfig, as this was >> lingering in one of my branches for a while. >> Patch 2 enables GPIO support for the H6, as this is needed for the Pine >> H64 to enable the VBUS regulator. >> Patch 3 adds the clock and reset gates mappings for the USB controller and >> the PHY, the values are taken from the manual and verified against >> Linux. >> Patch 4 adds some code to the PHY driver to skip over not implemented >> PHYs, as the H6 uses a PHY0/PHY3 combination in the DT. >> Patch 5 then eventually enables USB in the existing defconfigs. >> Patch 6 adds the .dts fixes required to get the upper USB port to work >> on the Pine H64. >> >> Clément, can you please verify that this works for the Beelink box? >> I guess the USB 2.0 port is probably the OTG one, so this setup would >> look somewhat similar to the PineH64, which would allow you to copy >> the USB DT nodes from there. >> >> Cheers, >> Andre. >> >> [1] https://lists.denx.de/pipermail/u-boot/2019-May/369520.html >> >> Andre Przywara (6): >> sunxi: move SUNXI_GPIO to Kconfig >> sunxi: gpio: Enable support for H6 pin controller >> sunxi: clocks: Add H6 USB clock gates and resets >> sunxi: phy: Add USB PHY support for Allwinner H6 >> sunxi: H6: Enable USB for existing boards >> sunxi: Pine64: DTS: enable USB PHY 0 for HCI0 > > Except 6/6 (it can be part of DTS sync during MW) and rest > > Reviewed-by: Jagan Teki <ja...@amarulasolutions.com> Thanks Jagan! I will do some minor fixes and drop the DT part in a v2, to be send as soon as possible. Cheers, Andre. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot