Hi On Wed, Jun 19, 2019 at 9:33 AM Shyam Saini <sh...@amarulasolutions.com> wrote: > > Hello Everyone, > > I tried to run "nand erase.part" and "nand erase.chip" on imx6ul isiot > board and it hangs up and after some time it starts to give this error > message: > > MXS NAND: DMA read error > MXS NAND: Error sending command >
Di di you check pinmux on the bus? I think that is not muxed. You are booting from mmc and the bootrom just not configure it because your boot sequence is prio on mmc Michael > I printed error number which was -110, did anybody else face this problem? > > I did try to erase nand with "flash_erase" from linux and it worked > with throwing any error. In and all it seems like a uboot issue. > > Thanks a lot, > Shyam -- | Michael Nazzareno Trimarchi Amarula Solutions BV | | COO - Founder Cruquiuskade 47 | | +31(0)851119172 Amsterdam 1018 AM NL | | [`as] http://www.amarulasolutions.com | _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot