Hi Mark, > Does anyone have a procedure to restore u-boot on a AMCC Canyonlands > board using the BDI2000? > > I have the bdisetup utility and the firmware/logic files for ppc4xx. I > also found the config files for BDI2000 but there is not a procedure to > program it. > > I have not used our BDI programmer before so this may be a stupid > question but I need to restore the image on a couple of boards now.
If you have setup the config file including the amount of nor flash to erase and the filename to load, it can boil down to "erase" followed by "prog" in the telnet prompt :) Check the "erase", "file", "format" lines in [flash]. Manually in the telnet interface you should be able to do an (untested) erase 0xfffa0000 erase 0xfffc0000 erase 0xfffe0000 prog 0xfffa0000 canyonlands/u-boot.bin bin Cheers Detlev -- I shall be telling this with a sigh / Somewhere ages and ages hence: / Two roads diverged in a wood, and I-- / I took the one less traveled by, / And that has made all the difference. -- Robert Frost -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-40 Fax: (+49)-8142-66989-80 Email: d...@denx.de _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot