There are few changes which need to be done for RevD and are not in TOT. I will send the patches for it soon.
Regards Poonam > -----Original Message----- > From: [email protected] [mailto:[email protected]] > On Behalf Of Felix Radensky > Sent: Monday, June 21, 2010 3:49 PM > To: U-Boot-Denx; Kumar Gala > Subject: [U-Boot] TOT u-boot makes P1020RDB unbootable > > Hi, > > I've tried to flash TOT u-boot complied with ELDK 4.2 for P1020_config > into my P1020RDB RevD and bricked it. The same u-boot boots fine on > P2020RDB revC. > > I don't have BDI3000 at the moment to debug the problem. It would be > great to fix it before the release. > > Below is u-boot output from P1020RDB running with u-boot-2009.11 from FSL > BSP > > U-Boot 2009.11-00001-g4458602-dirty (Feb 27 2010 - 11:13:42) > > CPU0: P1020E, Version: 1.0, (0x80ec0010) > Core: E500, Version: 5.0, (0x80212050) > Clock Configuration: > CPU0:800 MHz, CPU1:800 MHz, > CCB:400 MHz, > DDR:333.333 MHz (666.667 MT/s data rate) (Asynchronous), LBC:25 > MHz > L1: D-cache 32 kB enabled > I-cache 32 kB enabled > Board: P1020RDB RevD > I2C: ready > SPI: ready > DRAM: Configuring DDR for 666.667 MT/s data rate > DDR: 512 MB > NOR Flash Bank : Primary > SD/MMC : 4-bit Mode > eSPI : Enabled > FLASH: 16 MB > L2: 256 KB enabled > NAND: 32 MiB > MMC: FSL_ESDHC: 0 > EEPROM: Read failed. > eTSEC2 is in sgmii mode. > > PCIE2 connected to Slot 1 as Root Complex (base addr ffe09000) > PCIE2 on bus 00 - 01 > > PCIE1 connected to Slot 2 as Root Complex (base addr ffe0a000) > PCIE1 on bus 02 - 02 > > In: serial > Out: serial > Err: serial > Net: uploading VSC7385 microcode from ef000000 > eTSEC1: No support for PHY id ffffffff; assuming generic eTSEC1, eTSEC2, > eTSEC3 > > Thanks. > > Felix. > > _______________________________________________ > U-Boot mailing list > [email protected] > http://lists.denx.de/mailman/listinfo/u-boot _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
