Hi Stefano, On Wed, Jul 24, 2019 at 6:10 PM Igor Opaniuk <igor.opan...@gmail.com> wrote: > > For Colibri iMX6ULL we have to set pinmux for uart configuration ASAP > (ideally before relocation) to get serial console working. Without this > we miss almost the half of output (U-boot version, CPU defails, > Reset cause, DRAM details etc.). > > To achieve this we need to force pinctrl-mx6 to get probed before > relocation and add u-boot,dm-pre-reloc properties to uart pinmux > configuration nodes. Setting pinmux configuration for UART before was done > in board_early_init_f(). > > > Igor Opaniuk (3): > pinctrl: nxp: DM_FLAG_PRE_RELOC by default > ARM: dts: imx6ull-colibri: change hierarchy of DTS files > ARM: dts: imx6ull-colibri: pre-reloc for uart pinmux modes > > v2: > - Addressed comments [Fabio Estevam] > > arch/arm/dts/imx6ull-colibri-u-boot.dtsi | 12 + > arch/arm/dts/imx6ull-colibri.dts | 596 +------------------- > arch/arm/dts/imx6ull-colibri.dtsi | 641 ++++++++++++++++++++++ > board/toradex/colibri-imx6ull/MAINTAINERS | 2 + > drivers/pinctrl/nxp/pinctrl-imx5.c | 2 - > drivers/pinctrl/nxp/pinctrl-imx6.c | 2 - > drivers/pinctrl/nxp/pinctrl-imx7.c | 2 - > drivers/pinctrl/nxp/pinctrl-imx7ulp.c | 2 - > 8 files changed, 657 insertions(+), 602 deletions(-) > create mode 100644 arch/arm/dts/imx6ull-colibri-u-boot.dtsi > create mode 100644 arch/arm/dts/imx6ull-colibri.dtsi > > -- > 2.17.1 >
Could you please apply this patch-series (if there no any objections from your side, just let me know) to u-boot-imx? Thanks -- Best regards - Freundliche GrĂ¼sse - Meilleures salutations Igor Opaniuk mailto: igor.opan...@gmail.com skype: igor.opanyuk +380 (93) 836 40 67 http://ua.linkedin.com/in/iopaniuk _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot