> -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Albert Aribaud > Sent: Friday, July 09, 2010 12:11 AM > To: [email protected] > Subject: [U-Boot] [PATCH V3 4/4] edminiv2: add cmd_ide support > > This patch uses mv_sata_ide and cmd_ide to enable the use of the > integrated SATAHC controller port 1. > > Signed-off-by: Albert Aribaud <[email protected]> > --- > board/LaCie/edminiv2/edminiv2.c | 5 ++++ > include/configs/edminiv2.h | 47 > +++++++++++++++++++++++++++++++++++++- > 2 files changed, 50 insertions(+), 2 deletions(-) > > diff --git a/board/LaCie/edminiv2/edminiv2.c > b/board/LaCie/edminiv2/edminiv2.c > index 54c0ffe..6336429 100644 > --- a/board/LaCie/edminiv2/edminiv2.c > +++ b/board/LaCie/edminiv2/edminiv2.c > @@ -88,5 +88,10 @@ int board_init(void) > /* boot parameter start at 256th byte of RAM base */ > gd->bd->bi_boot_params = gd->bd->bi_dram[0].start + 0x100; > > + /* Enable SATA ports if SATA IDE was configured */ > +#if defined(CONFIG_MV_SATA_IDE) > + mv_sata_ide_initialize_port(orion5x_port1_sata_registers); > +#endif > + > return 0; > } > diff --git a/include/configs/edminiv2.h b/include/configs/edminiv2.h > index c3d95a0..1a61437 100644 > --- a/include/configs/edminiv2.h > +++ b/include/configs/edminiv2.h > @@ -52,6 +52,12 @@ > #define CONFIG_SYS_HZ 1000 > > /* > + * __io is necessary for cmd_ide to compile > + */ > + > +#define __io > + > +/* > * Board-specific values for Orion5x MPP low level init: > * - MPPs 12 to 15 are SATA LEDs (mode 5) > * - Others are GPIO/unused (mode 3 for MPP0, mode 5 for > @@ -60,7 +66,7 @@ > > #define ORION5X_MPP0_7 0x00000003 > #define ORION5X_MPP8_15 0x55550000 > -#define ORION5X_MPP16_23 0x00000000 > +#define ORION5X_MPP16_23 0x00005555 > > /* > * Board-specific values for Orion5x GPIO low level init: > @@ -74,7 +80,6 @@ > */ > > #define ORION5X_GPIO_OUT_ENABLE 0x03fcffff > -#define ORION5X_GPIO_OUT_VALUE 0x03fcffff
Why did you removed this? Regards.. Prafulla . . _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
