On Wed, Oct 23, 2019 at 5:47 AM <[email protected]> wrote: > > From: Nicolas Ferre <[email protected]> > > The KSZ8081 PHY has a factory test mode which is set at the de-assertion > of the reset line based on the RXER (KSZ8081RNA/RND) or TXC > (KSZ8081MNX/RNB) pin. If a pull-down is missing, or if the pin has a > pull-up, the factory test mode should be cleared by manually writing a 0 > (according to the datasheet). > Create another ksz8081_config function to handle this case. > > Suggested-by: Antoine Tenart <[email protected]> > Signed-off-by: Nicolas Ferre <[email protected]>
Acked-by: Joe Hershberger <[email protected]> _______________________________________________ U-Boot mailing list [email protected] https://lists.denx.de/listinfo/u-boot
