Fabio, On Tue, Dec 17, 2019 at 12:47 AM Fabio Estevam <[email protected]> wrote: > > Hi Igor, > > On Mon, Dec 16, 2019 at 6:16 PM Igor Opaniuk <[email protected]> wrote: > > > Sure, will do tomorrow morning asap.Btw, there is also a regression in MMC > > subsystem (currently AFK, will look into it and provide more details also > > tomorrow), probably the same as explained in the "i.MX8MM-EVK Boot failure" > > thread. > > What is the MMC error you see?
U-Boot 2019.10-00071-g9c1e982218 (Dec 17 2019 - 12:37:14 +0200) CPU: NXP i.MX8QXP RevB A35 at 1200 MHz DRAM: 2 GiB MMC: FSL_SDHC: 0, FSL_SDHC: 1 Loading Environment from MMC... Card did not respond to voltage select! *** Warning - No block device, using default environment In: serial@5a090000 Out: serial@5a090000 Err: serial@5a090000 Card did not respond to voltage select! MMC init failed MISSING TORADEX CONFIG BLOCK Model: Toradex Colibri iMX8X Build: SCFW 494c97f3 Boot: USB Net: Could not get PHY for FEC0: addr 2 eth-1: ethernet@5b040000 Hit any key to stop autoboot: 0 > It seems we need an equivalent of kernelci.org in U-Boot. We are > seeing lots of regression and we are close to the release. BTW, we are currently working (internally in Toradex) on LAVA-based solution for testing both U-boot (hopefully Linaro finally added support for testing bootloaders, [1]) and Linux kernel. We plan to automate testing of both BSP downstream and mainline trees, so it makes sense to configure (that's still under discussion) some interaction with ML, for example sending notification about regressions/automatic bi-secting results (analog of syzbot emails in LKML) etc. If you have any ideas - we're open to any suggestions/input. [1] https://connect.linaro.org/resources/bkk19/bkk19-409/ Thanks -- Best regards - Freundliche Grüsse - Meilleures salutations Igor Opaniuk mailto: [email protected] skype: igor.opanyuk +380 (93) 836 40 67 http://ua.linkedin.com/in/iopaniuk
