Hi Heiko, On Wed, Jan 8, 2020 at 2:41 AM Heiko Schocher <[email protected]> wrote:
> Looking into git history, there is a commit from you: > > commit 5b858582512883b8a85d74e108873f9beed1e954 > Author: Fabio Estevam <[email protected]> > Date: Wed Jun 12 12:34:40 2019 -0300 > > wandboard: Add FIT image support > > After the transition to DM, only the mx6dl/solo wandboard > is supported. > > Add FIT image support so that all the wandboard variants > can be supported, like it was prior to the DM conversion. > > Successfully booted Linux on mx6q/solo/qp wandboards. > > So it worked for you? I flashed the u-boot-fit-dtb.bin instead of > u-boot-dtb.bin, but this leads to: Just tested the latest u-boot-imx, which contains the PMIC fix and booting a imx6qp-wandboard-revd1 works fine: http://code.bulix.org/pncucj-1073321 This is the only revd1 wandboard I have access to. I flashed the SD card as per the board/wandboard/README instructions. Ethernet is also functional in U-Boot. The support for imx6q-wandboard-revd1 and imx6dl-wandboard-revd1 still needs to be added (it used to work prior to the DM conversion as you noticed), but unfortunately I don't have access to these variants. Regards, Fabio Estevam > > resetting ... > > U-Boot SPL 2020.01-tbot-00271-gd8a3f52 (Jan 08 2020 - 06:25:09 +0100) > Trying to boot from MMC1 > mmc_load_image_raw_sector: mmc block read error > spl: ext4fs_open failed > spl_load_image_ext: error reading image u-boot-dtb.img, err - -1 > SPL: failed to boot from all boot devices > ### ERROR ### Please RESET the board ### > > Same with u-boot-with-spl.imx flashed. > > I am sure I make here something wrong... any ideas? > > Attached also a working bootlog with an older version [1]. > > Thanks! > > bye, > Heiko > > [1] working U-Boot bootlog: > U-Boot SPL 2019.04-rc4-tbot-00111-gab8fc41 (Jan 08 2020 - 06:18:50 +0100) > Trying to boot from MMC1 > > > U-Boot 2019.04-rc4-tbot-00111-gab8fc41 (Jan 08 2020 - 06:18:50 +0100) > > CPU: Freescale i.MX6DL rev1.3 at 792 MHz > Reset cause: WDOG > I2C: ready > DRAM: 1 GiB > PMIC: PFUZE100 ID=0x10 > MMC: FSL_SDHC: 0, FSL_SDHC: 1 > Loading Environment from MMC... OK > No panel detected: default to HDMI > Display: HDMI (1024x768) > In: serial > Out: serial > Err: serial > Board: Wandboard rev D1 > Net: FEC [PRIME] > Hit any key to stop autoboot: 0 > => > > -- > DENX Software Engineering GmbH, Managing Director: Wolfgang Denk > HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany > Phone: +49-8142-66989-52 Fax: +49-8142-66989-80 Email: [email protected]
