On 1/13/20 4:07 PM, Patrick DELAUNAY wrote: > Hi Marek, > >> From: Marek Vasut <ma...@denx.de> >> Sent: lundi 13 janvier 2020 12:08 >> >> On 1/13/20 11:58 AM, Patrick DELAUNAY wrote: >>> Hi Marek, >>> >>>> From: Marek Vasut <ma...@denx.de> >>>> Sent: vendredi 10 janvier 2020 01:29 >>>> >>>> Setting TARGET_STM32MP1 in Kconfig always forces SYS_BOARD, >>>> SYS_VENDOR and SYS_CONFIG_NAME to values set by the ST reference >>>> platforms. Allow changing that by pulling out the >>>> TARGET_STM32MP157C_DK2 and making the ST reference platform settings >>>> conditional on >>>> TARGET_STM32MP157C_DK2 . >>>> Other platforms can now define a different TARGET_ and thus override >>>> the SYS_ settings in their Kconfig. >>> >>> Reviewed-by: Patrick Delaunay <patrick.delau...@st.com> >>> >>> It seens my configuration between SOC (STM32MP15x) and BOARD is not >> clean... >>> >>> So I prepare a patchset to change it. >>> But I will apply it after your serie... >>> to avoid regression on your board >>> >>> Regards Patrick >> >> Can you apply whatever you feel applicable from the series I posted and push >> it to >> some git repo, so I don't have to reset all things over and over again ? > > Sure. > > https://gitlab.denx.de/u-boot/custodians/u-boot-stm.git > > => branch master : the paches accepted > [V3] stm32mp1: configs: Make all boot devices in distro boot conditional > > [2/5] ARM: stm32: Allow overriding setup_mac_address() > > They will be included in my next pull request > > => branch next > + my serie = > http://patchwork.ozlabs.org/project/uboot/list/?series=152828 > + your serie (including my proposals of update) > http://patchwork.ozlabs.org/project/uboot/list/?series=152293 > > [3/5] ARM: stm32: Fill in missing loadaddr > => I change address to 0xc2000000 > > [5/5] ARM: dts: stm32: Add DH Electronics DHCOM SoM and PDK2 > board > I make a lot of modification after my serie and my > review.... > > Can you check the delta and tell me if it is working... > > > NB: no more needed after my serie => [1/5] ARM: stm32: Permit > multiple board targets i > > PS: [4/5] ARM: dts: stm32: Add missing ETHCK clock to ethernet > node > I ma waiting Christophe / kernel feedback.... >
Should be OK, thanks.
