On 2/9/20 3:59 AM, Bin Meng wrote:
On Sun, Feb 9, 2020 at 8:38 AM Heinrich Schuchardt <[email protected]> wrote:
The network connection speed is a debug information. So we should use
debug() and not printf().
Signed-off-by: Heinrich Schuchardt <[email protected]>
---
drivers/net/designware.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/net/designware.c b/drivers/net/designware.c
index 19fc34f771..a89f4bedf1 100644
--- a/drivers/net/designware.c
+++ b/drivers/net/designware.c
@@ -255,9 +255,9 @@ static int dw_adjust_link(struct dw_eth_dev *priv, struct
eth_mac_regs *mac_p,
writel(conf, &mac_p->conf);
- printf("Speed: %d, %s duplex%s\n", phydev->speed,
- (phydev->duplex) ? "full" : "half",
- (phydev->port == PORT_FIBRE) ? ", fiber mode" : "");
+ debug("Speed: %d, %s duplex%s\n", phydev->speed,
+ (phydev->duplex) ? "full" : "half",
+ (phydev->port == PORT_FIBRE) ? ", fiber mode" : "");
Maybe this was intentional as I see such in the MACB driver as well.
Leaving this to Joe and original author of this driver to comment.
Thanks for reviewing.
In my syslog driver
https://lists.denx.de/pipermail/u-boot/2020-February/399551.html
I got this message everytime that I initialized the network.
Best regards
Heinrich
