> From: Robert Beckett <bob.beck...@collabora.com> > Remove old (pre-DM) i2c setup code. > Enable DM i2c. > Convert common code to use DM rtc. > Convert common code to read VPD from eeprom partition. > Convert the generic i2c PMIC init code to use the new da9063 driver. > mx53ppd only: > Correct RTC compatible in device tree. > Enable MXC DM i2c driver. > Define CONFIG_SYS_MALLOC_F_LEN so that DM is available in pre-reloc. > Make GPIO banks available during preloc, since initialisation is done > in board_early_init_f(). > Add gpio_request() calls to satisfy the DM_GPIO compatibility API. > Remove unused power configuration. > Signed-off-by: Robert Beckett <bob.beck...@collabora.com> > Signed-off-by: Ian Ray <ian....@ge.com> Applied to u-boot-imx, master, thanks !
Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de =====================================================================
