From: Charles Frey <[email protected]> The mpc8xx watchdog can work either in 'reset mode' or 'NMI mode'. The selection can be done at startup only. It is desirable to select the mode without rebuilding U-boot. It is also desirable to disable the watchdog without rebuilding.
At watchdog startup, check environment variable 'watchdog_mode'. If it is 'off', the watchdog is not started. If it is 'nmi', the watchdog is started in NMI mode. Otherwise, it is started in reset mode which is the default mode. Signed-off-by: Charles Frey <[email protected]> Signed-off-by: Christophe Leroy <[email protected]> --- drivers/watchdog/mpc8xx_wdt.c | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-) diff --git a/drivers/watchdog/mpc8xx_wdt.c b/drivers/watchdog/mpc8xx_wdt.c index 675b62d8b3..8a7a4c5bc6 100644 --- a/drivers/watchdog/mpc8xx_wdt.c +++ b/drivers/watchdog/mpc8xx_wdt.c @@ -4,6 +4,7 @@ */ #include <common.h> +#include <env.h> #include <dm.h> #include <wdt.h> #include <mpc8xx.h> @@ -21,8 +22,15 @@ static void hw_watchdog_reset(void) static int mpc8xx_wdt_start(struct udevice *dev, u64 timeout, ulong flags) { immap_t __iomem *immap = (immap_t __iomem *)CONFIG_SYS_IMMR; + u32 val = CONFIG_SYS_SYPCR; + const char *mode = env_get("watchdog_mode"); - out_be32(&immap->im_siu_conf.sc_sypcr, CONFIG_SYS_SYPCR); + if (strcmp(mode, "off") == 0) + val = val & ~(SYPCR_SWE | SYPCR_SWRI); + else if (strcmp(mode, "nmi") == 0) + val = (val & ~SYPCR_SWRI) | SYPCR_SWE; + + out_be32(&immap->im_siu_conf.sc_sypcr, val); if (!(in_be32(&immap->im_siu_conf.sc_sypcr) & SYPCR_SWE)) return -EBUSY; -- 2.25.0
