ROC-RK3399-PC has specific set of configurations for on-board led setup. Due to easiness for user to know the state of the board roc-rk339-pc board code will setup the low power led on/off, and waiting for user to press power key and then glow full power led.
All this needs to happen only during power-on-reset not for soft reset or WDT. So add reset cause check to POR and configure the low power leds, power key only. Note that the glowing red led is common across any reset. Reported-by: Markus Reichl <[email protected]> Signed-off-by: Jagan Teki <[email protected]> --- Changes for v2: - glow red led to common across reboots board/firefly/roc-pc-rk3399/roc-pc-rk3399.c | 24 ++++++++++++--------- 1 file changed, 14 insertions(+), 10 deletions(-) diff --git a/board/firefly/roc-pc-rk3399/roc-pc-rk3399.c b/board/firefly/roc-pc-rk3399/roc-pc-rk3399.c index de9185a7ce..6cc81952d8 100644 --- a/board/firefly/roc-pc-rk3399/roc-pc-rk3399.c +++ b/board/firefly/roc-pc-rk3399/roc-pc-rk3399.c @@ -33,6 +33,7 @@ out: #endif #if defined(CONFIG_TPL_BUILD) +#include <asm/arch-rockchip/cru.h> #define PMUGRF_BASE 0xff320000 #define GPIO0_BASE 0xff720000 @@ -42,18 +43,21 @@ int board_early_init_f(void) struct rockchip_gpio_regs * const gpio0 = (void *)GPIO0_BASE; struct rk3399_pmugrf_regs * const pmugrf = (void *)PMUGRF_BASE; - /** - * 1. Glow yellow LED, termed as low power - * 2. Poll for on board power key press - * 3. Once 2 done, off yellow and glow red LED, termed as full power - * 4. Continue booting... - */ - spl_gpio_output(gpio0, GPIO(BANK_A, 2), 1); + /* Set the low power leds, power key only during POR */ + if (!strcmp(get_reset_cause(), "POR")) { + /* 1. Glow yellow LED, termed as low power */ + spl_gpio_output(gpio0, GPIO(BANK_A, 2), 1); - spl_gpio_set_pull(&pmugrf->gpio0_p, GPIO(BANK_A, 5), GPIO_PULL_NORMAL); - while (readl(&gpio0->ext_port) & 0x20); + /* 2. Poll for on board power key press */ + spl_gpio_set_pull(&pmugrf->gpio0_p, + GPIO(BANK_A, 5), GPIO_PULL_NORMAL); + while (readl(&gpio0->ext_port) & 0x20); - spl_gpio_output(gpio0, GPIO(BANK_A, 2), 0); + /* 3. Once 2 done, turn off yellow */ + spl_gpio_output(gpio0, GPIO(BANK_A, 2), 0); + } + + /* 4. Turn on red LED, termed as full power */ spl_gpio_output(gpio0, GPIO(BANK_B, 5), 1); return 0; -- 2.17.1
