Hi folks Since include/ide.h defines IDE_BUS(dev) as (dev >> 1), it ignores the values of CONFIG_SYS_IDE_MAXBUS and CONFIG_SYS_MAXDEVICE, and unconditionally expects an IDE bus to have two devices.
This expectation falls down with the Orion5x SATA support, which uses that SATA controller in IDE compatability mode, but can obviously only have one device per bus. I'm not 100% sure whether the problem is with the IDE code, or with the Orion5x code which identifies a drive at both "positions" on the IDE bus. i.e. if I define CONFIG_SYS_IDE_MAXDEVICE as (CONFIG_SYS_IDE_MAXBUS*2), I get the first drive shown twice, and the second drive shown twice. The following RFC patch works for me, but may well break other boards that do not define CONFIG_SYS_IDE_MAXDEVICE and CONFIG_SYS_IDE_MAXBUS properly: diff --git a/include/ide.h b/include/ide.h index 6a1b7ae..3f81fb1 100644 --- a/include/ide.h +++ b/include/ide.h @@ -24,7 +24,7 @@ #ifndef _IDE_H #define _IDE_H -#define IDE_BUS(dev) (dev >> 1) +#define IDE_BUS(dev) (dev >> (CONFIG_SYS_IDE_MAXDEVICE / CONFIG_SYS_IDE_MAXBUS - 1)) #define ATA_CURR_BASE(dev) (CONFIG_SYS_ATA_BASE_ADDR+ide_bus_offset[IDE_BUS(dev)]) Ok, I'm sure it is line wrapped, tab-damaged, etc, and the line itself is too long, but conceptually, would that be acceptable? Thanks Rogan _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot