Dear Wolfgang, > -----Original Message----- > From: Martinez, Aldo > Sent: Friday, July 16, 2010 1:30 AM > To: u-boot@lists.denx.de > Cc: Paulraj, Sandeep; w...@denx.de; Martinez, Aldo > Subject: [PATCH 0/2 v5][U-BOOT] Zoom3: Add support for OMAP3630 Zoom3 > board. > > From: Aldo Brett Cedillo Martinez <aldo.cedi...@ti.com> > > This patch set gives basic functionality to Omap3630 Zoom3 board. And > unifies serial_devices for zoom2 and zoom3 since both use the same > struct. > > Thanks Wolfgang for your comments, the modifications done were: > - Added entry to MAINTAINERS in proper order. > - Macro for UART1_RX pin. > - Left include for status led unconditional. > - Unindented preprocessor statements. > - Made CONFIG_SYS_HZ a constant with value 1000. > - Zoom2 and Zoom3 devices now use the same serial device. > > Aldo Brett Cedillo Martinez (2): > [U-BOOT] Zoom3: Add support for OMAP3630 Zoom3 board. > [U-BOOT] Unify serial_device for zoom2 and zoom3.
I wonder what is the status of this patch? Sandeep commented me it was dependent on another patch, maybe a serial driver patch. The second patch of this series affects include/serial.h, should I make any modifications to patch so it can apply? Thanks and best regards, Aldo _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
