Dear Patrick,
In message <8970fb86c1374d1999ff656c2a327...@sfhdag6node3.st.com> you wrote:
>
> > > - ret = uclass_get_device(UCLASS_CLK, 0, &dev);
> > > - if (ret) {
> > > - debug("Clock init failed: %d\n", ret);
> > > - return;
> > > - }
> > > + clk = uclass_get_device(UCLASS_CLK, 0, &dev);
> > > + if (clk)
> > > + debug("%s: Clock init failed: %d\n", __func__, clk);
> > >
> > > - ret = uclass_get_device(UCLASS_RESET, 0, &dev);
> > > - if (ret) {
> > > - debug("Reset init failed: %d\n", ret);
> > > - return;
> > > - }
> > > + reset = uclass_get_device(UCLASS_RESET, 0, &dev);
> > > + if (reset)
> > > + debug("%s: Reset init failed: %d\n", __func__, reset);
> > >
> > > - ret = uclass_get_device(UCLASS_PINCTRL, 0, &dev);
> > > - if (ret) {
> > > - debug("%s: Cannot find pinctrl device\n", __func__);
> > > - return;
> > > - }
> > > + pinctrl = uclass_get_device(UCLASS_PINCTRL, 0, &dev);
> > > + if (pinctrl)
> > > + debug("%s: Cannot find pinctrl device: %d\n",
> > > + __func__, pinctrl);
> > >
> > > /* enable console uart printing */
> > > preloader_console_init();
> > >
> > > + if (clk || reset || pinctrl)
> > > + printf("%s: probe failed clk=%d reset=%d pinctrl=%d\n",
> > > + __func__, clk, reset, pinctrl);
> > > +
> >
> > This change makes little sense to me/ If you want error messages, then
> > just turn
> > above debug() into printf(), and be done with it.
> > As an additional benefit so see at once which step failed.
>
> In this patch, I try to display error as soon as console is available
> (after preloader_console_init) , if after one driver initialization
> (clk, reset, pincontrol) failing.
>
> Change debug to printf only works only if CONFIG_DEBUG_UART
> is activated (not by default) and board_debug_uart_init() exist to configure
> the needed UART TX pins.
Maybe you can remember an error code so you can tell the user which
of the steps failed? That would be more useful, then.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
I know engineers. They love to change things. - Dr. McCoy
