>-----Original Message----- >From: Ioana Ciornei <[email protected]> >Sent: Friday, May 15, 2020 12:27 PM >To: Priyanka Jain <[email protected]>; [email protected] >Cc: Ioana Ciornei <[email protected]> >Subject: [PATCH v2 1/3] board: ls2080aqds: transition to DM_ETH > >In case CONFIG_DM_ETH is enabled, no hardcoding is necessary for DPAA2 >Ethernet devices. Compile out any unnecessary setup when CONFIG_DM_ETH >is activated. Also, force the PCI devices to be enumerated at probe time. > >Signed-off-by: Ioana Ciornei <[email protected]> >--- > board/freescale/ls2080aqds/eth.c | 13 +++++++++++-- > board/freescale/ls2080aqds/ls2080aqds.c | 4 ++++ > 2 files changed, 15 insertions(+), 2 deletions(-) > >diff --git a/board/freescale/ls2080aqds/eth.c >b/board/freescale/ls2080aqds/eth.c >index bbb70a859a1e..47f57d94b847 100644 >--- a/board/freescale/ls2080aqds/eth.c >+++ b/board/freescale/ls2080aqds/eth.c >@@ -24,6 +24,8 @@ > > #define MC_BOOT_ENV_VAR "mcinitcmd" > >+#ifndef CONFIG_DM_ETH >+ > #if defined(CONFIG_FSL_MC_ENET) && !defined(CONFIG_SPL_BUILD) > /* - In LS2080A there are only 16 SERDES lanes, spread across 2 SERDES >banks. > * Bank 1 -> Lanes A, B, C, D, E, F, G, H >@@ -889,9 +891,11 @@ void ls2080a_handle_phy_interface_xsgmii(int i) > } > } > #endif >+#endif // !CONFIG_DM_ETH > > int board_eth_init(bd_t *bis) > { >+#ifndef CONFIG_DM_ETH > int error; > #if defined(CONFIG_FSL_MC_ENET) && !defined(CONFIG_SPL_BUILD) > struct ccsr_gur __iomem *gur = (void *)CONFIG_SYS_FSL_GUTS_ADDR; >@@ -970,8 +974,13 @@ int board_eth_init(bd_t *bis) > sgmii_configure_repeater(2); > } > #endif >- error = pci_eth_init(bis); >- return error; >+#endif // !CONFIG_DM_ETH >+ >+#ifdef CONFIG_DM_ETH >+ return 0; >+#else >+ return pci_eth_init(bis); >+#endif > } > > #if defined(CONFIG_RESET_PHY_R) >diff --git a/board/freescale/ls2080aqds/ls2080aqds.c >b/board/freescale/ls2080aqds/ls2080aqds.c >index 4034bdee2842..1c91c5b7f052 100644 >--- a/board/freescale/ls2080aqds/ls2080aqds.c >+++ b/board/freescale/ls2080aqds/ls2080aqds.c >@@ -251,6 +251,10 @@ int board_init(void) > ppa_init(); > #endif > >+#if !defined(CONFIG_SYS_EARLY_PCI_INIT) && defined(CONFIG_DM_ETH) >+ pci_init(); >+#endif >+ > return 0; > } > >-- >2.17.1 Please fix below build warning:
-(ls2080aqds_nand ls2080aqds_sdcard) int error; -(ls2080aqds_nand ls2080aqds_sdcard) ^~~~~ w-(ls2080aqds_nand ls2080aqds_sdcard) ../board/freescale/ls2080aqds/eth.c: In function â board_eth_initâ : w-(ls2080aqds_nand ls2080aqds_sdcard) ../board/freescale/ls2080aqds/eth.c:899:6: warning: unused variable â errorâ [-Wunused-variable] Regards Priyanka
